Sprinkler Coverage Calculator
Most patchy lawns were lost on paper before a trench was dug: heads spaced by their diameter instead of their radius, so every head’s throw falls short of its neighbour and the gaps dry out. The professional rule is head-to-head coverage — spacing equals radius. This calculator lays out your rectangle on that rule, in square or the more even triangular pattern.
Use the radius your heads achieve at your pressure, not the box maximum — a 15 ft head on a weak supply may throw 11 ft, and the layout must be drawn for 11. When in doubt, bucket-and-tape one head in the yard first.
How to use this calculator
- Measure the area: length × width.
- Enter the throw radius your heads really achieve at your pressure.
- Choose square (simple grid) or triangular (offset rows, most even).
- Read head count and spacings, then print the layout.
How the maths works: head-to-head means each head is spaced one radius from the next, so its throw lands exactly on its neighbour — the overlap is what makes coverage uniform, because a sprinkler's own circle is driest at its edge. Triangular layouts space rows at radius × 0.866 and offset them half a spacing, closing the thin spots a square grid leaves. Once heads are counted, the Sprinkler Calculator turns them into a precipitation rate and run time. The full coverage guide covers edges, curves and mixed shapes.
What are you using this for?
Tell us what you are making, and we will help you do it yourself. Type your project below and we will show you the full method, step by step, using the estimate you just made.
A worked example
A 60 ft × 40 ft lawn with 15 ft heads, square pattern: heads every 15 ft — 5 along the length × 4 rows = 20 heads. Triangular: rows close up to 13 ft (5 rows on the grid) with alternate rows offset half a spacing, covering the same ground more evenly. Spaced by diameter instead (30 ft), the same lawn would get about 6 heads and a polka-dot of dry rings by July.
Keep going
Heads laid out? The Sprinkler Calculator converts the zone into a precipitation rate and run times. For beds and borders, drip usually wins — the Drip Irrigation Calculator plans it, and the Drip Flow Rate Calculator checks its lines.
Questions people ask
What does 'head-to-head coverage' actually mean?
That every head is close enough to its neighbours for its spray to land on them — spacing equal to the throw radius. A sprinkler applies the least water at the edge of its own circle, so without overlap those edges stack into dry rings. It feels extravagant on paper and is simply how uniform coverage works.
Square or triangular spacing — which is better?
Triangular is measurably more even: offsetting rows by half a spacing closes the square grid's thin diagonal gaps, and it is the professional default for open lawn. Square is easier to lay out and to repair, and in narrow or rectangular areas the difference shrinks. Either beats any spacing wider than the radius.
Can I space heads a bit wider to save money?
You can, and the lawn will invoice you later — in dry spots, reseeding and extra hand-watering. If budget bites, shrink the irrigated area or phase the install; spacing wider than the radius is the one economy that always costs more than it saves.
My yard is not a rectangle — how do I adapt the grid?
Break it into rectangles and near-rectangles, lay each out on the same spacing, and let part-circle heads handle the edges and curves. The grid discipline stays identical inside each block; only the boundary heads change their arcs.
Why is my real throw shorter than the box says?
The box radius assumes the rated pressure at the head, adequate flow, and still air. Undersized pipe, a long run, low street pressure or wind all shorten it. Design with the radius you measure in your yard — tape from the head to where its water actually lands on a calm morning.